| The float arm (where pictured) may ship detached to prevent damage in transit. To connect, simply snap the wire end into the sender hole. |
| TYC 150025 Specifications |
|---|
| Accessories Included | Yes | | Connector Pins Qty On Main Connector | 7 Pins | | Fuel Level Sensor Resitance Range | 15-160 | | Fuel Tube Connection Type | Quick Connect | | GPH (Gallons Per Hour Flow) | 41.0-54 | | Maximum Air Pressure | 80-116 | | Strainer Included | Yes |
|
|
TYC's Commitment to Quality
- Design: All TYC products are meticulously designed using the most advanced simulation software and tooling development technology.
- Processes: The latest technologies are used in the creation of all TYC products.
- Vehicle Test Fit: Prototypes are created and mounted onto a vehicle. Any adjustment needed is made prior to market release to ensure drop-in, hassle-free installation.
- Accelerated Fatigue Test: An array of tests is conducted to assure top-notch quality products. Fatigue tests, such as abrasion, humidity, rain, salt spray, and vibration are applied to meet or exceed DOT/SAE and industry standards.
Product Features:
- Pump design improves the flow rate over the original to ensure sufficient fuel overcomes the resistance that may be present in older vehicles' fuel delivery tubes.
- Full individual testing for functionality before leaving the factory
- Exhaustive testing that includes SAE 1537 compliance, which considers durability, noise, and simulated contaminated fuel with granules.
 Benefits of Purchasing a Fuel Pump & Housing Assembly Purchasing just the fuel pump is less expensive up-front, but a complete Fuel Pump & Housing Assembly provides added benefits:
- Extend Service Life: New strainer(s), hoses, sensors and other components help resolve problems that could be caused by more than just the pump.
- Reduce Install Time: Since you don't have to disassemble the housing, which could lead to damage, replacement becomes a simple swap, dramatically reducing installation time.
- Save Money: The cost of the assembly is often cheaper than buying the components individually, and means you only have to do the job once.
 Prevent Premature Fuel Pump Failure Preventing premature fuel pump failure is far less expensive and time consuming than continuing to replace the pump. There are three common causes for premature fuel pump failure:
| ELECTRICAL ISSUES |
Poor electrical connections will mimic symptoms of a failed pump, sometimes resulting in unnecessary replacement. Before replacing the pump:
- Use a Fuel System Tester to test pump pressure is within expected range
- Use an Electrical Tester to test for bad wiring, burnt or corroded connectors
- Check / Replace faulty Fuse(s) and Relay
BEFORE REPLACEMENT |
| FUEL CONTAMINATION |
Dirt, rust or debris in the fuel can clog strainers and stick to internal pump components. When replacing the pump:
- Replace Fuel Filter or Fuel Strainer
- Empty and clean the tank with Fuel Tank Cleaner
- Fill tank with fresh, uncontaminated fuel of appropriate grade
DURING REPLACEMENT |
| PUMP DAMAGE / OVERHEATING |
Running low on gas causes your fuel to heat up quicker, and your pump to work harder. After replacing the pump:
- Maintain at least 1/4 tank of fuel and use a Fuel Additive / Conditioner to keep pump cool and lubricated
- If vehicle is stored without use, drain tank to prevent pump corrosion from fuel oxidation
AFTER REPLACEMENT |
|
| OEM / Interchange Numbers: 1F1Z9H307A |
TYC Warranty Information:Limited Lifetime for non-commercial useWarranty Details |
|
