DASH 4
More Information for DASH 4 CD610
Continue Shopping
 
DASH 4 CD610close
<
>
Part image
Brake Pads are sold as a set. Quantity of one (1) is for both wheels
Dash 4 Brake Pads are manufactured using the same positive molding process utilized by Original Equipment Suppliers. The positive molding process uses an extreme amount of pressure to compress the friction material and bond it to the backing plate. This post-cured process assures the consistent performance throughout the service life of the brake pad, while preventing rust and corrosion.

Installation Tips
  • Suspend the caliper from the suspension using a Caliper Hanger to prevent damage to the brake hose
  • Apply Brake Lube to caliper pins, clips, the edges of the brake pad mounting tabs, and the back side of the brake pads to ensure noise free braking. DO NOT apply lube to the friction side of the brake pads
  • Use a Caliper Piston Compressor to retract the caliper piston(s) and make room for the new, thicker brake pads
  • Open the master cylinder reservoir during piston compression to prevent pressure buildup. Keep an eye on the Brake Fluid level to ensure it does not overflow
  • After the job is complete, pump the brake pedal several times to push the caliper piston back up against the pads to ensure proper brake function

Attention California Customers - WARNING: This product can expose you to carbon black, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov