GATES 32979
|
|
($4.65/Each)
Price
|
$0.00
Core
|
+ Sold in packs of 10x10
Pack
|
$46.50
Total
|
|
|
|
GATES 32979 Specifications |
---|
Adjustment Type | Thermoplastic | Band Width | 1.5" | Material | Thermoplastic | Maximum Diameter | 3.25" | Minimum Diameter | 3" | Nominal Hose I.D. (IN) | 2.75 | Size | SB79 |
|
|
Thermoplastic - Size SB79 (Nominal Hose I.D. 2 3/4", Fits Hose O.D. 3" to 3 1/4") |
Made of a heat-sensitive material, Gates PowerGrip™ SB clamp solves coolant
leakage problems in both silicone and standard rubber wall hoses, even on out-of-round
fittings.
- Gates thermoplastic clamp maintains a dynamic tension so that it never
needs retightening. Whenever the engine reaches operating temperture, the
shrink forces of PowerGrip SB readjust to a consistent clamping force. In
addition, its clamping force increases as the temperature drops below 40 degrees
F, thereby tightening the connection.
- Cold leaks, which normally occur when the temperature drops below 40 degrees
F, are eliminated.
- Installation using a heat gun is fast and easy, including hard-to-reach
places. Heat-gun attachments permit installation in confining areas that would
be extremely difficult to reach using a screwdriver on conventional orm-drive
screw clamps.
- The PowerGrip SB hose clamp features a smooth surface that won't rust, corrode,
or result in cut fingers during installation.
- PowerGrip SB hose clamps are completely resistant to all automotive fluids
including oil, antifreeze and even brake fluid.
- Wider than conventional clamps, PowerGrip SB hose clamps can be positioned
over the raised bead on the end of the fitting nipple - even cast metal.
- PowerGrip SB clamps are readily removed with Gates' specially-designed clamp
removal tool. The clamps also can be removed using a soldering iron to melt
through the thermoplastic material.
- Sizes are available for 1/4 through 3-1/8 inch I.D. hose.
|
OEM / Interchange Numbers: 42979 |
|