|
REIN PSH0535
|
|
$38.79
Price
|
$0.00
Core
|
+ Sold in packs of 1x1
Pack
|
$38.79
Total
|
|
|
|
|
|
| REIN PSH0535 Specifications |
|---|
| Banjo Bolt Included | No | | Clamps Included | Not Required | | Color | Black | | Crush Washers Included | Not Required | | Fitting Seals Included | Not Required | | Heat Shield Included | Not Required | | High Pressure End 1 Gender | Male | | High Pressure End 1 Thread Diameter (MM) | 16.0000 | | High Pressure End 1 Type | Inverted Flare | | High Pressure End 2 Gender | Male | | High Pressure End 2 Thread Diameter (MM) | 16.0000 | | High Pressure End 2 Type | Inverted Flare | | Hose Line Lining | Steel | | Hose Line Outer Material | Steel | | Low Pressure End 1 Gender | Male | | Low Pressure End 1 Thread Diameter (MM) | 17.0000 | | Low Pressure End 1 Type | Inverted Flare | | Low Pressure End 2 Inside Diameter (MM) | 8.0000 | | Low Pressure End 2 Outside Diameter (MM) | 10.0000 | | Low Pressure End 2 Type | Tube | | Mounting Brackets Included | Yes | | Power Steering Fitting Included | Yes | | Pressure Switch Port Included | Not Required | | Protective Sleeve Included | Not Required | | Tubing Finish | Zinc Alloy | | Tubing Material | Carbon Steel |
|
|
Features:- A direct fit, replacement line assembly
- SAE J526 compliant coated, rust resistant heavy duty tubing and end fittings
- Pre assembled coated, rust resistant hose crimp end(s) and bracket(s), where required
- Pre attached protective jacket(s) and heat sleeve(s), where required
 Installation Tips - Replace all power steering hoses at the same time, to prevent system contamination
- Completely flush the system with an OE approved Power Steering Fluid prior to installation (the correct type of fluid is noted on the reservoir cap or in your owner's manual). Flushing the system is critical to prevent system contamination and failure
- Install the replacement hose in reverse order of how it was removed, making sure to install any included o-rings. Lubricate the o-rings with Silicone Grease and carefully install them, to prevent damage. Make sure the hose is not touching or rubbing against any components that vibrate or give off heat
- Consider installing a Power Steering Filter on the Power Steering Return Hose to prevent system contamination and extend the life of the power steering components
|
| OEM / Interchange Numbers: 4441007030 |
REIN Warranty Information:24 Months, 24,000 Miles |
|
