Complete kit contains everything required for making professional-quality repairs in just minutes. State-of-the-art components and easy-to-follow instructions with photographs. Provides a low-cost, high-quality repair for damaged rear window defogger grids and tabs. Quick Grid™ is the result of a joint research project with the General Motors Research Center.
Suggested Applications: Rear window defogger grids and tabs.
Instructions for Use: This product will work only on tabs that have become detached from the side grid of electric defogger. This product will not work on bare wires that have been soldered to window grid and have been removed. Surfaces to be adhered must be smooth and flat. Read all directions before beginning repair. Repairs can be made ideally at temperatures from 50°F to 75°F (10°C to 24°C).
- Turn off the rear defogger. Carefully remove the tab from the wire assembly
- Ensure that the tab is flat and makes complete contact with the mounting surface
- Clean the lead attachment area on the rear window and tab with alcohol towelette. Note: DO NOT mount the tab on the same grid area if the grid has been removed from the glass. There must be grid so that a complete circuit can be made.
- If the grid has come off with the tab, rub the tab on a flat piece of 180 grit or finer sand paper until the surface is flat and of the same color.
- Grasp the corners of the Cleaner-Activator Towelette Packet and gently pull apart until green towelette is completely visible. DO NOT REMOVE TOWELETTE FROM PROTECTIVE FOIL COVER
- Hold the Cleaner-Activator Towelette by the back of the protective foil cover. Wipe the grid area of the window where the tab is to be attached and wipe the mounting surface of the tab itself. Allow the activator to dry for at least 2 minutes. (Tab must be attached within 15 minutes of activation). DO NOT TOUCH the grid mounting surface or the tab
- Thoroughly knead the tab adhesive pouch until the adhesive is of a uniform beige color. Do this by the placing pouch on a firm surface and moving adhesive back and forth with fingernail.
- Cut the top of the pouch. Apply one drop of adhesive to the surface of the tab
- Immediately apply tab to rear window grid; hold firmly for 1 minute
- Allow 24 hours to cure before turning on defogger. If a multi meter is available, check between tab and grid for continuity. There should be 0 ohms resistance between the tab and grid
- Uncured adhesive around the tab may be cleaned off with alcohol
Attention California Customers - Warning: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
|
