REIN
More Information for REIN PSH0463
Continue Shopping
 
REIN PSH0463  
$25.79
Price
$0.00
Core
+ Sold in packs of 1x1
Pack
$25.79
Total
REIN PSH0463close
<
>
Part image
REIN PSH0463 Specifications
Clamps IncludedYes
End 1 GenderMale
End 1 Thread Diameter (MM)16.0000
End 1 TypeInverted Flare
End 2 Inside Diameter (MM)10.0000
End 2 Outside Diameter (MM)18.0000
End 2 TypeHose
Fitting Seals IncludedYes
Heat Shield IncludedNot Required
Hose Burst Pressure PSI750
Hose Line LiningSteel Rubber
Hose Line Outer MaterialSteel Rubber
Hose MaterialNBR/CR
Hose Operating Pressure PSI250
Mounting Brackets IncludedNot Required
Power Steering Fitting IncludedYes
Protective Shield IncludedNo
Protective Sleeve IncludedNot Required
Tubing FinishPVF Resin
Tubing MaterialCarbon Steel
Features:
  • A direct fit, replacement hose and line assembly
  • OE quality, braided rubber compound hose
  • Coated, rust resistant heavy duty tubing and end fittings
  • Pre assembled coated, rust resistant hose crimp end(s) and bracket(s), where required
  • Pre attached protective jacket(s) and heat sleeve(s), where required
Installation Tips
  • Replace all power steering hoses at the same time, to prevent system contamination
  • Completely flush the system with an OE approved Power Steering Fluid prior to installation (the correct type of fluid is noted on the reservoir cap or in your owner's manual). Flushing the system is critical to prevent system contamination and failure
  • Install the replacement hose in reverse order of how it was removed, making sure to install any included o-rings. Lubricate the o-rings with Silicone Grease and carefully install them, to prevent damage. Make sure the hose is not touching or rubbing against any components that vibrate or give off heat
  • Consider installing a Power Steering Filter on the Power Steering Return Hose to prevent system contamination and extend the life of the power steering components
OEM / Interchange Numbers: 4440602010

REIN Warranty Information:
24 Months, 24,000 Miles