Maval Industries has been remanufacturing steering products for over 30 years.
Remanufacturing Process:
Housings, shafts and critical components are thoroughly cleaned using the latest technology to greatly reduce the potential for contamination, and inspected thoroughly to detect any cracks or leaks
Shafts and housings are polished, bearings and snap rings are replaced to restore rack performance and eliminate leaks
Electronic solenoids are tested to verify proper performance
All seals, PTFE and O-rings are replaced with new, OE-equivalent components to prevent leaks, ensure longevity and reliability
A protective paint coating is applied, bellows and fasteners are high-quality components to protect against corrosion, rust and optimize the longevity of the unit
Tested using state-of-the-art test equipment to simulate actual operational conditions, inspecting for leaks, noises, and overall functionality to ensure the unit meets or exceeds OE specifications
100 percent centered after testing to reduce installation time
