NUGEON
More Information for NUGEON 9717632A
{Alternate Inventory Numbers: 97-17632A, 2217632R}
Continue Shopping
 
NUGEON 9717632A  
$27.79
Price
$25.00
Core
+ Sold in packs of 1x1
Pack
$52.79
Total
NUGEON 9717632Aclose
<
>
Part image
NUGEON 9717632A Specifications
Anti-Squeal Shims IncludedNo
Bleeder Screw Cap IncludedNo
Bleeder Screw IncludedYes
Bleeder Screw Thread (MM)M10-1.5 x 29.5
Bleeder Thread SizeM10-1.5
Bracket IncludedNo
Bracket Mounting Bolts IncludedNo
Caliper And Pad Hardware IncludedNo
Caliper Casting MaterialCast Iron
Caliper ColorGray
Caliper FinishRust Preventative
Dust Boots IncludedYes
Hardware IncludedYes
Inlet Fitting TypeBanjo Bolt
Inlet Port Thread Size (MM)M10-1.5 x 23.14
Inlet Thread SizeM10-1.5
New Or RemanufacturedRemanufactured
Pads IncludedNo
Piston 1 Outside Diameter (in)3
Piston 1 Outside Diameter (mm)86
Piston MaterialSteel
Piston Quantity1
Wear Sensors IncludedNo
Reman
Manufactured under the strictest quality standards in an ISO 14001:2004-registered factory, NuGeon semi-loaded calipers are built from O.E. castings to ensure the same fit and function as a new O.E. unit. Only the best cores, without wear, corrosion or blemishes are selected for the NuGeon line. All components used are of the highest quality and every unit is pressure-tested with the same machines and parameters that are used at O.E.M. factories.

Features & Benefits:
  • End-of-line pressure testing for leakage
  • Piston replacement with same piston material as O.E. (phenolic/aluminum)
  • Semi-loaded for end-user's choice of brake pad design and/or brand
  • Pad hardware and brackets included in box
  • Slider pins come pre-greased ensuring proper caliper movement and brake system stability
  • New pin boots reduce the chance that moisture and contaminates will cause corrosion
  • All rubber components are replaced assuring brakes perform at an optimal level
  • Banjo bolts and copper crush washers provided (where applicable) to assure proper seat on the brake inlet and caliper housing
  • New bleed screws ensure an airtight seal
Installation Tips
  • Always inspect brake pads and rotors when replacing your calipers. Faulty calipers can lead to uneven pad and rotor wear
  • Inspect or change brake hoses when replacing the caliper. Worn or damaged hoses should be replaced to prevent brake fluid contamination or loss
  • Use a Brake Fluid Tester to test your brake fluid. If your brake fluid has moisture in it, flush the system before installing the new caliper
  • Apply Blue Threadlocker to caliper bracket mounting bolts to lock the bolts in place and prevent loosening or backing out
  • After installing the new caliper, bleed your brakes to ensure no air is trapped in the brake fluid. RockAuto offers a selection of Brake Bleeding Tools to help with this process
  • After the brakes have been bled, top off the master cylinder reservoir with the proper Brake Fluid

Attention California Customers - WARNING: Cancer and Reproductive Harm


Attention California Customers - Y


Closeout Inventory Warranty Information:
Wholesaler Closeout items have a 30 day warranty (but still are covered by our Return Policy).

NUGEON Regular Inventory Warranty Information:
Limited Lifetime