BRUTE POWER
More Information for BRUTE POWER 1010078
Continue Shopping
 
BRUTE POWER 1010078  
$64.89
Price
 $0.00
Core
 + Sold in packs of 1x1
Pack
 $64.89
Total
Add to Cart
BRUTE POWER 1010078close
Part image
The float arm (where pictured) may ship detached to prevent damage in transit. To connect, simply snap the wire end into the sender hole.
BRUTE POWER 1010078 Specifications
ContentsFUEL PUMP, FUEL PRESSURE REGULATOR, SENDING UNIT, FLOAT, FUEL RESERVOIR, FUEL STRAINER, TANK SEAL
Inlet TypeStrainer
Maximum Flow Rating65
Maximum Pressure110
Outlet Thread Diameter0.375
Outlet TypeQuick Connect
Voltage12
Improved Design with Internal Strainer

Brute Power brings its automotive knowledge and high quality standards to Fuel Pumps!

Features:

  • Re-engineered in the USA to provide OEM matching form and performance
  • Innovative designs overcome common OE problems
  • Stainless steel or appropriately plated metal components
  • Ethanol compatible hoses and FKM rubber seals
  • Motor armatures with carbon commutator and plastic over-molded sealed copper windings
  • Endurance testing to ensure durability in low lubricity high ethanol fuels
  • 20% and 85% Ethanol component soak testing
Benefits of Purchasing a Fuel Pump & Housing Assembly

Purchasing just the fuel pump is less expensive up-front, but a complete Fuel Pump & Housing Assembly provides added benefits:

  • Extend Service Life: New strainer(s), hoses, sensors and other components help resolve problems that could be caused by more than just the pump.
  • Reduce Install Time: Since you don't have to disassemble the housing, which could lead to damage, replacement becomes a simple swap, dramatically reducing installation time.
  • Save Money: The cost of the assembly is often cheaper than buying the components individually, and means you only have to do the job once.
Prevent Premature Fuel Pump Failure

Preventing premature fuel pump failure is far less expensive and time consuming than continuing to replace the pump. There are three common causes for premature fuel pump failure:

ELECTRICAL ISSUES
Poor electrical connections will mimic symptoms of a failed pump, sometimes resulting in unnecessary replacement. Before replacing the pump:
  • Use a Fuel System Tester to test pump pressure is within expected range
  • Use an Electrical Tester to test for bad wiring, burnt or corroded connectors
  • Check / Replace faulty Fuse(s) and Relay

BEFORE REPLACEMENT
FUEL CONTAMINATION
Dirt, rust or debris in the fuel can clog strainers and stick to internal pump components. When replacing the pump:
  • Replace Fuel Filter or Fuel Strainer
  • Empty and clean the tank with Fuel Tank Cleaner
  • Fill tank with fresh, uncontaminated fuel of appropriate grade

DURING REPLACEMENT
PUMP DAMAGE / OVERHEATING
Running low on gas causes your fuel to heat up quicker, and your pump to work harder. After replacing the pump:
  • Maintain at least 1/4 tank of fuel and use a Fuel Additive / Conditioner to keep pump cool and lubricated
  • If vehicle is stored without use, drain tank to prevent pump corrosion from fuel oxidation

AFTER REPLACEMENT
OEM / Interchange Numbers: 4897667AA, 4897667AE, 4897667AF

BRUTE POWER Warranty Information:
Limited Lifetime