NUGEON
More Information for NUGEON 99P17307B
Continue Shopping
 
NUGEON 99P17307B  
$35.79
Price
$50.00
Core
+ Sold in packs of 1x1
Pack
$85.79
Total
NUGEON 99P17307Bclose
<
>
Part image
NUGEON 99P17307B Specifications
Anti-Squeal Shims IncludedNo
Bleeder Screw Cap IncludedNo
Bleeder Screw IncludedYes
Bleeder Screw Thread (MM)M10-1.5 x 29.5
Bleeder Thread SizeM10-1.5
Bracket Cast Numbers710
Bracket IncludedYes
Bracket Mounting Bolts IncludedNo
Caliper And Pad Hardware IncludedYes
Caliper Casting MaterialCast Iron
Caliper ColorGray
Caliper FinishRust Preventative
Caliper Slides IncludedYes
Dust Boots IncludedYes
Hardware IncludedYes
Housing Cast Numbers18025722, L03, L
Inlet Fitting TypeBanjo Bolt
Inlet Port Thread Size (MM)M10-1.5 x 23.14
Inlet Thread SizeM10-1.5
New Or RemanufacturedRemanufactured
Pads IncludedNo
Piston 1 Outside Diameter (in)2
Piston 1 Outside Diameter (mm)57
Piston MaterialPhenolic
Piston Quantity2
Wear Sensors IncludedNo
TechShield 360; Includes Mounting Bracket
Every NuGeon Techshield 360°™ caliper is remanufactured under the highest quality standards to meet or exceed the specifications required by the original design, and tested during the assembly process for leaks, free moving pistons, and smooth bracket sliding. TechShield 360™ is a proprietary electrodeposition coating applied to brake calipers via an automated submersion process.

Features & Benefits:
  • The electrodeposition coating is applied via submersion, and not a spray, offering more consistent and uniform coverage of both the housing and the bracket (where included)
  • The electrodeposition coating passes a 96-hour continuous salt spray validation test
  • The coating is environmentally friendly, heavy metal-free, and OSHA and EPA compliant
  • Every caliper is pressure tested to ensure brakes perform at optimum level
  • New bleeder screws provide trouble-free bleeding and an air-tight seal
  • Pre-lubricated guide bolts on mounting brackets save installation time and prevent seizing
  • 100% S.A.E. specific rubber seals ensure like-new performance
  • Banjo bolts, copper crush washers and parking brake cable brackets, levers and return springs all preinstalled for easy installation
Installation Tips
  • Always inspect brake pads and rotors when replacing your calipers. Faulty calipers can lead to uneven pad and rotor wear
  • Inspect or change brake hoses when replacing the caliper. Worn or damaged hoses should be replaced to prevent brake fluid contamination or loss
  • Use a Brake Fluid Tester to test your brake fluid. If your brake fluid has moisture in it, flush the system before installing the new caliper
  • Apply Blue Threadlocker to caliper bracket mounting bolts to lock the bolts in place and prevent loosening or backing out
  • After installing the new caliper, bleed your brakes to ensure no air is trapped in the brake fluid. RockAuto offers a selection of Brake Bleeding Tools to help with this process
  • After the brakes have been bled, top off the master cylinder reservoir with the proper Brake Fluid

Attention California Customers - WARNING: Cancer and Reproductive Harm


Attention California Customers - Y


NUGEON Warranty Information:
Limited Lifetime