SBI
Mehr Informationen über SBI 2302186
weiter einkaufen
 
SBI 2302186  
Nicht vorrätig
Preis
Kühlernetz
Verpackung
Summe
SBI 2302186close
Part image

If an Overhead Cam Cylinder Head has been excessively machined the distance between the Cam and the Crank centerline is too small. This will affect the valve timing and the engine will not run properly. There is also a very good chance that the engine will not pass emissions tests. SBI Head Saver Shims are designed to replace this lost height and restore the centerline distance. These Shims are 0.020” thick and are made from steel. They should be installed on the block surface directly under the Head Gasket. Overhead Valve Cylinder Heads are also good candidates for shims. Surface machining reduces combustion chamber size boosting the compression ratio and potential for gasket failure. On V6 and V8 OHV heads, thinner heads can cause intake manifold misalignment. The Head Saver Shim corrects this.


SBI Garantie Information:
12 Monate gegen Material- oder Herstellungsfehler