NISSENS
More Information for NISSENS 940701
Continue Shopping
 
NISSENS 940701  
$91.79
Price
$0.00
Core
+ Sold in packs of 1x1
Pack
$91.79
Total
NISSENS 940701close
<
>
Part image
NISSENS 940701 Specifications
Core Height12.1300 IN
Core Length26.5700 IN
Core MaterialAluminum
Core Width0.6300 IN
Includes DrierWithout integrated dryer
Refrigerant TypeR134a
TypeCorrosion Protected
w/ Corrosion Protection

Features & Benefits

  • Long-life product through high-resistance corrosion protection layer applied on the exchanger surface
  • Designed, manufactured and tested in full accordance to requirements for OE products
  • Perfect finish in every detail such as connections, threads, bolts, mountings and is an exact fit for the vehicle mounting points
  • Optimized aluminum brazing processes significantly reduce surface impurities caused by residues of brazing pre-treatment agents
  • Inlet and outlet connections covered by tight closures protecting against impurities and moist absorption during production and storage
An Introduction to Nissens A/C Condensers (Video)

Benefits of Additional Corrosion Protection

Aluminum doesn't rust but can corrode, especially when exposed to road salt and other elements on the front of a vehicle. Corrosion is an insulator, reducing a condenser's heat exchange capacity and putting extra wear on the A/C Compressor and other components. Corrosion may cause a puncture, venting environmentally harmful refrigerant into the air and requiring an expensive repair and recharge. A condenser with Additional Corrosion Protection extends the lifespan of the whole A/C system!

Installation Tips
  • Old Refrigerant must be removed from the system in accordance with local, state, and federal laws.
  • Replace the A/C System O-Rings / Seals connected to the A/C Condenser to prevent a Refrigerant leak.
  • If the new A/C Condenser does not have an integrated drier, replace the A/C Receiver Drier / Accumulator as well. After opening your A/C System, this part becomes saturated with moisture and needs to be replaced.
  • After installing the new A/C Condenser, evacuate the system for at least 45 minutes to remove any moisture. Make sure it holds vacuum for at least 5 minutes. If it does not, you may have a leak in the system. Find the leaking component and repair or replace it.
  • Recharge the system with the correct amount and type of Refrigerant as specified in your Owner's Manual.
OEM / Interchange Numbers: 5191252AA, 68004052AA, 68004052AB, K05191252AA, K68004052AA, K68004052AB

Warranty Information:
12 Months