|
PERMATEX 27010
|
|
$10.76
Price
|
$0.00
Core
|
+ Sold in packs of 1x1
Pack
|
$10.76
Total
|
|
|
|
|
|
|
|
|
| High Strength Threadlocker RED Gel; 10 g |
OEM specified. Gel formula provides liquid-reliability without drips, globs, mess or waste. High strength threadlocker for heavy-duty applications 3/8 inch to 1 inch (10mm to 25mm). Especially well suited for permanently locking studs and press fits. Adds 3,000 PSI holding power on slip and press fit assemblies. Replaces set screws and snap rings. Locks against vibration loosening. May require heat or special tools for removal. Temperature range: -65°F to 300°F. Conforms to ASTM D5363 AN0221 (Mil-S-46163A, Type I, Grade K).
Directions:
- Parts should be clean and oil free.
- Remove protective cap.
- Turn dial to expose 1/8" to 1/4" of material beyond tip.
- Apply threadlocker to leading edge of male fitting, covering 5 to 6 threads. Avoid direct contact of tip to metal surface.
- Assemble parts and tighten to recommended torque.
- Replace protective cap.
NOTE: Permatex® Threadlocker Gel should not be used on plastic fittings.
Attention California Customers - WARNING: Cancer. www.P65Warnings.ca.gov
|
|
