More Information for CENTRIC 12146035
Continue Shopping
CENTRIC 12146035  
CENTRIC 12146035close
Part image
Sold Individually
CENTRIC 12146035 Specifications
ABS Sensor Ring IncludedNo
Bolt Circle Diameter (IN)4.500
Bolt Circle Diameter (MM)114.300
Disc MountingFloating
Discard Thickness (IN)0.882
Discard Thickness (MM)22.400
Misc Holes4
Nominal Thickness (IN)0.945
Nominal Thickness (MM)24.000
Outside Diameter (IN)10.866
Outside Diameter (MM)276.000
Overall Height (IN)1.772
Overall Height (MM)45.000
Solid Or Vented Type RotorVented
Surface TypeSmooth
Vane StyleStraight
Centric C-Tek brake rotors provide exceptional quality and value.

Features & Benefits:
  • Non-Directional Finish
  • Machined non-friction surfaces
  • G11H18 metallurgy

Installation Tips
  • Always replace Brake Pads and inspect Calipers and Brake Hoses when installing new rotors
  • Suspend the caliper from the suspension using a Caliper Hanger to prevent damage to the brake hose
  • After removing the old rotor, clean the hub face with a Wire Brush to remove rust buildup and apply Copper Anti Seize to prevent future buildup. Rust or debris on the hub can cause rotor runout and lead to wheel vibration
  • Apply Brake Lube to caliper pins, clips, the edges of the brake pad mounting tabs, and the back side of the brake pads to ensure noise free braking. DO NOT apply lube to the friction side of the brake pads
  • Use a Caliper Piston Compressor to retract the caliper piston(s) and make room for the new, thicker brake pads
  • Open the master cylinder reservoir during piston compression to prevent pressure buildup. Keep an eye on the Brake Fluid level to ensure it does not overflow
  • After the job is complete, pump the brake pedal several times to push the caliper piston back up against the pads to ensure proper brake function

Attention California Customers -

Attention California Customers - WARNING: Cancer and Reproductive Harm

Alternate/OEM Part Number(s): 121.46035

CENTRIC Warranty Information:
90 days/3,000 miles