CENTRIC
More Information for CENTRIC 32066035F
Continue Shopping
 
CENTRIC 32066035Fclose
<
>
Part image
CENTRIC 32066035F Specifications
Abs Tone Ring IncludedYes
Bearings IncludedNo
Bolt Thread Pitch1.500 mm
Center Hole Diameter3.134 IN; 79.600 mm
Disc FinishFully Coated
Disc MountingHub & Rotor
Discard Thickness1.215 IN; 30.860 mm
Hat FinishCoated
Inner Bearing #410.91005
Inner Seal #417.66004
Misc Holes0
Mounting Bolt Hole Circle Diameter139.700 mm; 5.500 IN
Nominal Thickness1.287 IN; 32.700 mm
Outer Bearing #410.91003
Overall Height114.300 mm; 4.500 IN
Rotor Outside Diameter (IN)11.614
Rotor Outside Diameter (mm)295.000
Solid Or Vented Type RotorVented
Stud Thread Diameter14.000 mm
Stud/Lug Hole Quantity6
Surface TypeSmooth
Vane StyleStraight
GCX Elemental Protection Disc Brake Rotors; Full Coating; Rotor & Hub

GCX Brake Rotors are specifically engineered to match OE performance and provide superior protection from rust and corrosion. Coated with Centric's advanced RS200 finish on all non-mating surfaces, GCX premium rotors deliver extended life and great looks over the life of the vehicle.

Features & Benefits:
  • Zinc-Aluminum rich coating for the best corrosion resistance
  • Optimal surface finish for consistent and confident braking from the first stop
  • OE vane design and plate thickness for heat capacity and strength
  • Low initial lateral run-out and disc thickness variation for smooth, vibration free stopping
  • Precision balanced for vibration free performance
Installation Tips
  • Always replace Brake Pads and inspect Calipers and Brake Hoses when installing new rotors
  • Suspend the caliper from the suspension using a Caliper Hanger to prevent damage to the brake hose
  • After removing the old rotor, clean the hub face with a Wire Brush to remove rust buildup and apply Copper Anti Seize to prevent future buildup. Rust or debris on the hub can cause rotor runout and lead to wheel vibration
  • Apply Brake Lube to caliper pins, clips, the edges of the brake pad mounting tabs, and the back side of the brake pads to ensure noise free braking. DO NOT apply lube to the friction side of the brake pads
  • Use a Caliper Piston Compressor to retract the caliper piston(s) and make room for the new, thicker brake pads
  • Open the master cylinder reservoir during piston compression to prevent pressure buildup. Keep an eye on the Brake Fluid level to ensure it does not overflow
  • After the job is complete, pump the brake pedal several times to push the caliper piston back up against the pads to ensure proper brake function


Videos

Why Choose Centric GCX Rotors?

Prop 65 Warning Symbol
WARNING:

Attention California Customers - WARNING: Cancer and Reproductive Harm. See www.p65warnings.ca.gov

CENTRIC Warranty Information:
90 days/3,000 miles