More Information for FVP 6620431
Continue Shopping
FVP 6620431  
FVP 6620431close
Part image
FVP 6620431 Specifications
Center Hole Diameter (IN)2.165
Discard Thickness (IN)0.748
Mounting Bolt Hole Circle Diameter (IN)3.937
Mounting Bolt Hole Quantity (EA)4
Nominal Thickness (IN)0.866
Outside Diameter (IN)10.039
Overall Height (IN)1.823
Solid Or Vented Type RotorVented
FVP Coated Rotors fix the “rusty” issue by coating the hat, side and vanes with a corrosion resistant paint, ensuring a long lasting OE look even in the harshest environments.

  • Coated with gray corrosion-resistant paint on hat, vanes and edge to keep OE look and feel
  • Engineered to provide OE Quality and Performance
  • Manufactured to OE thickness and vane configuration specs
  • Mill-balanced and Machined with a Non-Directional Finish
Installation Tips
  • Always replace Brake Pads and inspect Calipers and Brake Hoses when installing new rotors
  • Suspend the caliper from the suspension using a Caliper Hanger to prevent damage to the brake hose
  • After removing the old rotor, clean the hub face with a Wire Brush to remove rust buildup and apply Copper Anti Seize to prevent future buildup. Rust or debris on the hub can cause rotor runout and lead to wheel vibration
  • Apply Brake Lube to caliper pins, clips, the edges of the brake pad mounting tabs, and the back side of the brake pads to ensure noise free braking. DO NOT apply lube to the friction side of the brake pads
  • Use a Caliper Piston Compressor to retract the caliper piston(s) and make room for the new, thicker brake pads
  • Open the master cylinder reservoir during piston compression to prevent pressure buildup. Keep an eye on the Brake Fluid level to ensure it does not overflow
  • After the job is complete, pump the brake pedal several times to push the caliper piston back up against the pads to ensure proper brake function

Warranty Information:
Limited Lifetime