More Information for FVP 91476
Continue Shopping
FVP 91476  
+ Sold in packs of 1x1
(Only 1 Remaining)
FVP 91476close
Part image
FVP 91476 Specifications
OE Comparison RatingOE Performance
Length (IN)50.4375
End 1 Diameter (MM)16
End 1 TypeMale O-Ring
End 2 Diameter (MM)18
End 2 TypeMale O-Ring
Includes Switch PortNo
  • High quality construction for long life: procote tubing, hypalon hose
  • Engineered to be equal to or better than the OE design and specifications
  • Includes replacement seals or gaskets, where required, to complete the job right the first time
Installation Tips
  • Replace all power steering hoses at the same time, to prevent system contamination
  • Completely flush the system with an OE approved Power Steering Fluid prior to installation (the correct type of fluid is noted on the reservoir cap or in your owner's manual). Flushing the system is critical to prevent system contamination and failure
  • Install the replacement hose in reverse order of how it was removed, making sure to install any included o-rings. Lubricate the o-rings with Silicone Grease and carefully install them, to prevent damage. Make sure the hose is not touching or rubbing against any components that vibrate or give off heat
  • Consider installing a Power Steering Filter on the Power Steering Return Hose to prevent system contamination and extend the life of the power steering components

Attention California Customers - WARNING: Using this product can expose you to 1,3Butadiene, a chemical known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov. Wash hands after handling. (18)

Warranty Information:
Limited Lifetime