|
STANDARD MOTOR PRODUCTS S20443
|
|
$287.79
Price
|
$0.00
Core
|
+ Sold in packs of 1x1
Pack
|
$287.79
Total
|
|
|
|
|
|
| STANDARD MOTOR PRODUCTS S20443 Specifications |
|---|
| Connector Gender | Female | | Connector Quantity | 1 | | Contents | Electronic Throttle Body | | Gasket or Seal Included | No | | Idle Air Control Motor Included | No | | Mounting Hardware Included | No | | Terminal Gender | Male | | Terminal Quantity | 6 | | Terminal Type | Pin |
|
|
Features:- All Fuel Injection Throttle Bodies meet or exceed OE performance, providing you with the quality parts needed to get the job done right, the first time
- As an expert Electronic Throttle Body manufacturer, SMP maintains complete quality control throughout the entire manufacturing process. They assemble and calibrate the components matching OE output voltages to facilitate the relearn process
- 100% NEW, never remanufactured, which maximizes performance and extends service life
- Direct-fit OE replacement ensures proper fit, form, and function for ease of installation
- Gasket included for required applications
- Engineering upgrades plus extensive endurance testing for extra-durability
- All SMP-manufactured ETBs are built in their North American IATF 16949-certified facility
Experiencing Acceleration or Idling Issues? It Might Not be the Throttle Body!
Poor acceleration, hesitation and other idling issues can be caused by failure of a variety of parts. Use the chart below to help determine which part is causing the problem.
| Part | System | Other Symptoms |
|---|
| Throttle Body | Fuel & Air | |
| Mass Air Flow Sensor | Exhaust & Emission | - Difficulty Starting or Turning Engine
|
| Air Filter | Fuel & Air | - Dark Filter Media
- Debris in Filter or Filter Box (Change every year!)
|
| Fuel Injector | Fuel & Air | |
| Vacuum Hose / Connector | Hoses / Lines & Clamps | - Hissing, Squealing or Sucking Sound from Cracked Connector or Hose (Use a Vacuum Tester)
|
|
Spark Plug or Spark Plug Wire or Ignition Coil
| Ignition | - Increase in Exhaust Emissions
- Visible Wire Damage
- Oil Leak
|
| Accelerator Pedal Position Sensor | Interior | - Limp Mode
- No / Delayed Pedal Response
|
 Installation Tips - Perform OEM Recommended idle relearn procedure. Some applications may require the use of an OBD Scan Tool while others may refer to the Owners Manual.
- A relearn of idle values can be forced by disconnecting the negative battery cable for several minutes in order to clear the electronic control module's memory.
- Several minutes of idling and highway driving may be necessary to relearn idle values. Electrical loads such as headlights, AC, radio, etc. should be turned off while relearning.
- Erratic idle or engine surging after installation of replacement unit may be resolved by putting a load on the engine. If idle evens out after shifting into gear, shift back into park and check idle RPM - perform relearn again if a drivability condition is present.
- Clean intake manifold mounting surface and replace Intake Manifold Gasket, if necessary.
- Inspect Air Cleaner Intake Hose for cracks and proper sealing - replace or repair with Multi-Purpose Sealant, if necessary.
- Check harness for broken wires and wiggle connector to try and reproduce the problem. Replace or clean Connector, if necessary.
- Clear all diagnostic trouble codes from vehicle computer prior to idle relearn.
|
| OEM / Interchange Numbers: 2203025010, 22030F0010 |
|
