Mass Air Flow Sensor - Complete Assembly, Jumper Harness, Instruction Sheet
Terminal Gender
Male
Terminal Quantity
5
Terminal Type
Blade
Wire Quantity
3
Wiring Harness Included
Yes
Full Assembly w/ Housing
Every Delphi Mass Airflow Sensor is built with calibrated, all-new components, and is never remanufactured. Delphi mass air flow sensors are designed and tested to meet or exceed OE requirements, and are engineered for a perfect fit.
Replacing the Complete Housing Assembly instead of the Sensor Only ensures the connector air tubes are clean and protects the sensor element, which can be damaged by air pollution or oils on your hands.
Check for Vacuum Leaks First!
Vacuum leaks present symptoms similar to a faulty MAF Sensor. When replacing the MAF, always check for vacuum leaks, too. Common sources include:
Leaking Intake Manifold Gasket (found in the "Engine" category) - Vacuum Gauge readings below 17-22 in-Hg (normal manifold vacuum at sea level) at idle may indicate an intake manifold gasket leak.
Note: As elevation increases, readings decrease. Subtract 1 in-Hg from normal manifold vacuum reference for every 1,000 feet increase in elevation above 2,000 feet.
Stuck open PCV Valve - remove the PCV Valve and gently shake it; if it does not rattle, the valve is clogged or dirty and should be replaced.
Cracked Intake Boot (found in the "Engine" category)
Videos
Cleaning Your MAF Sensor
Additional Resources
RockAuto Newsletter: Maintaining the Optimal Air/Fuel Mixture Attention California Customers - WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or reproductive harm. For more information go to www.P65Warnings.ca.gov.
Check for Vacuum Leaks First!
Videos
Additional Resources
RockAuto Newsletter: