AIMCO
More Information for AIMCO 54025
Continue Shopping
 
AIMCO 54025close
Part image
Sold Individually
AIMCO 54025 Specifications
TypeSolid
ConfigurationRotor Only
Number of Bolt Holes5
Bolt Circle Diameter4.25
Nominal0.555
Machine To0.502
Discard0.502

AIMCO® premium drums and rotors meet original equipment fit, form and function specifications. These drums and rotors provide peace of mind by providing safe, consistent, smooth braking each and every time the brakes are applied.

  • Exceptional value
  • Great quality
  • Long-lasting
Installation Tips
  • Always replace Brake Pads and inspect Calipers and Brake Hoses when installing new rotors
  • Suspend the caliper from the suspension using a Caliper Hanger to prevent damage to the brake hose
  • After removing the old rotor, clean the hub face with a Wire Brush to remove rust buildup and apply Copper Anti Seize to prevent future buildup. Rust or debris on the hub can cause rotor runout and lead to wheel vibration
  • Apply Brake Lube to caliper pins, clips, the edges of the brake pad mounting tabs, and the back side of the brake pads to ensure noise free braking. DO NOT apply lube to the friction side of the brake pads
  • Use a Caliper Piston Compressor to retract the caliper piston(s) and make room for the new, thicker brake pads
  • Open the master cylinder reservoir during piston compression to prevent pressure buildup. Keep an eye on the Brake Fluid level to ensure it does not overflow
  • After the job is complete, pump the brake pedal several times to push the caliper piston back up against the pads to ensure proper brake function