More Information for RAYBESTOS 980674
Continue Shopping
RAYBESTOS 980674  
RAYBESTOS 980674close
Part image
Sold Individually
RAYBESTOS 980674 Specifications
Discard Thickness (IN)1.024
Discard Thickness (MM)26.000
Inside Diameter (IN)9.291
Inside Diameter (MM)236.000
Mounting Bolt Hole Quantity5
Nominal Thickness (IN)1.102
Nominal Thickness (MM)28.000
Outside Diameter (IN)13.579
Outside Diameter (MM)344.900
Overall Height (IN)2.425
Overall Height (MM)61.600
Rotor TypeDrum-in-Hat
Solid Or Vented Type RotorVented
Surface TypeSmooth
Wheel Bolt Circle Diameter (IN)4.500
Wheel Bolt Circle Diameter (MM)114.300
Wheel Bolt Holes5
Specialty - Street Performance Disc
Raybestos® Street Performance Rotors deliver a stronger bite without sacrificing smooth braking. Each rotor is made with application-specific enhanced iron, which suppresses noise and keeps brakes running cool, quiet and vibration free.

Features & Benefits:
  • Carbon Enhanced Iron Material maximizes noise suppression and increases thermal conductivity to keep brakes running cool, quiet and vibration free
  • Cooling vanes match OE configurations, providing optimal cooling, reduced fade and increased pad life
  • Each rotor is coated to reduce rust for optimal airflow, cooling and aesthetics
  • Meet the SAE standard for tensile strength, guaranteeing structural integrity and maximum service life
  • A turned finish minimizes noise and improves responsiveness for smoother stops
  • Lateral runout of 0.002” or less and a minimal thickness variation of less than 0.0004”, ensuring less pedal pulsation, less brake noise, and extended pad life

Installation Tips
  • Always replace Brake Pads and inspect Calipers and Brake Hoses when installing new rotors
  • Suspend the caliper from the suspension using a Caliper Hanger to prevent damage to the brake hose
  • After removing the old rotor, clean the hub face with a Wire Brush to remove rust buildup and apply Copper Anti Seize to prevent future buildup. Rust or debris on the hub can cause rotor runout and lead to wheel vibration
  • Apply Brake Lube to caliper pins, clips, the edges of the brake pad mounting tabs, and the back side of the brake pads to ensure noise free braking. DO NOT apply lube to the friction side of the brake pads
  • Use a Caliper Piston Compressor to retract the caliper piston(s) and make room for the new, thicker brake pads
  • Open the master cylinder reservoir during piston compression to prevent pressure buildup. Keep an eye on the Brake Fluid level to ensure it does not overflow
  • After the job is complete, pump the brake pedal several times to push the caliper piston back up against the pads to ensure proper brake function

Warranty Information:
Limited Lifetime. Warranty covers defects in materials and workmanship. Normal/uneven wear is not covered