These parts may arrive in a box that says BXT or Supreme. The parts inside are the same.
MEVOTECH H512206 Specifications
Anti Lock Brake Sensor Included
Yes
Bearing Generation
Gen 3
Flange Bolt Hole Quantity
4
Inside Diameter
62.0 MM
Outside Diameter
152.0 MM
Pre-Greased
Yes
Wheel Stud Quantity
5
BXT / Supreme
Mevotech Supreme Parts are engineered in-house, with application-specific upgrades for increased durability and performance. Mevotech Supreme hub bearing assemblies are built for high-usage commercial and passenger vehicles, SUVs, fleets and working trucks.
Features & Benefits:
Precise Signal Quality: Increased gauge and strain reliefs provide ABS cable with abrasion resistance and increased cable strength.
Pre-Filled With Premium Grease: Premium lubricant withstands high temperature, extreme pressure, resists corrosion and reduces friction.
Premium Seal For Contaminant Protection: Multi-point sealing system provides layers of defense to keep contaminants out and vital grease in.
Superior Durability: High-grade materials are used on all components for longer part life.
Rigorously Tested: Extensive in-house and third-party durability testing ensures ultimate performance and strength
During installation, use a Torque Wrench to tighten the axle nut to the manufacturer's specification. Do not use an impact wrench as it is easy to over tighten the axle nut. The torque specification can be found in your owner's manual
Symptoms Of A Failing Wheel Bearing & Hub
Wheel hub units are low maintenance parts, but that doesn’t mean they last forever. Uneven road surfaces, heavy driving conditions (such as towing or racing), and under-inflated tires put extra strain on the hub bearing and can lead to premature failure. Common signs of a bad hub unit include:
A humming, rumbling or growling noise that increases with acceleration
A loud constant whining or grinding noise when the vehicle is in motion
Excessive play in the steering wheel
Steering wheel vibration that changes with the vehicle speed or as the vehicle turns
ABS system malfunction
How To Identify The Faulty Wheel Bearing & Hub
It is often difficult to pinpoint which hub unit has gone bad while driving because noise and vibration
travels through the frame of the vehicle. Here are a two tests you can do to help identify which hub unit has gone bad:
Shake Test: Identifying Play or Looseness
Lift your vehicle so the wheel is off the ground
Place your hands on the sides of the tire and try to shake the wheel
Now place your hands on the top and bottom of the tire and try to shake the wheel again
If you feel movement in both directions, you have play in your bearing and it needs to be replaced
Note: If you feel movement when shaking the wheel left to right, but not top to bottom, you could have a worn out tie rod end. Similarly, if you have movement top to bottom, but not left to right, you may have a worn out ball joint.
Spin Test: Identifying Noise or Grinding
Lift your vehicle so the wheel is off the ground and can spin freely
Spin the wheel, in either direction, and listen for a grinding or howling noise
If you hear a loud grinding or howling noise, that increases with the speed of the wheel, you have a failed bearing that needs to be replaced
Note: It is best to test both front or both rear bearings at the same time so you can compare the difference between the two sides. If you have a failed bearing, there will be a noticeable difference in the amount of noise you hear during this test