More Information for CENTRIC 12562138
Continue Shopping
CENTRIC 12562138  
CENTRIC 12562138close
Part image
Sold Individually
CENTRIC 12562138 Specifications
ABS Sensor Ring IncludedNo
Bolt Circle Diameter (IN)4.528
Bolt Circle Diameter (MM)115.000
Disc MountingFloating
Discard Thickness (IN)1.063
Discard Thickness (MM)27.000
Hat FinishCoated
Hat ID (IN)6.276
Hat ID (MM)159.400
Misc Holes1
Nominal Thickness (IN)1.181
Nominal Thickness (MM)30.000
Outside Diameter (IN)12.638
Outside Diameter (MM)321.000
Overall Height (IN)2.409
Overall Height (MM)61.200
Solid Or Vented Type RotorVented
Surface TypeSmooth
Vane StyleStraight
High Carbon Alloy
Centric High Carbon Alloy Rotors contain an advanced metallurgy that greatly reduces the possibility of pad squeal, especially with higher friction, European style brake pad compounds. Proprietary Molybdenum and Chromium alloys resist rotor cracking during high performance use or repeat stop situations. This alloy also increases the friction couple improving brake performance and stopping power. Increased Chromium and Carbon content is also more resistant to oxidation.

Features & Benefits:

  • Symmetric vane castings enable proper heat transfer and thermal efficiency, resulting in superior braking power
  • Black E-Coat anti-corrosive coating protects the cooling vanes and mounting surfaces from rusting prematurely
  • Double disc ground friction surface finish virtually eliminates run out and any disc thickness variation issues
  • Mill Balancing reduces rotor vibration and ensures smooth operation at all speeds
  • Non-directional finish for improved rotor and pad break-in

Installation Tips
  • Always replace Brake Pads and inspect Calipers and Brake Hoses when installing new rotors
  • Suspend the caliper from the suspension using a Caliper Hanger to prevent damage to the brake hose
  • After removing the old rotor, clean the hub face with a Wire Brush to remove rust buildup and apply Copper Anti Seize to prevent future buildup. Rust or debris on the hub can cause rotor runout and lead to wheel vibration
  • Apply Brake Lube to caliper pins, clips, the edges of the brake pad mounting tabs, and the back side of the brake pads to ensure noise free braking. DO NOT apply lube to the friction side of the brake pads
  • Use a Caliper Piston Compressor to retract the caliper piston(s) and make room for the new, thicker brake pads
  • Open the master cylinder reservoir during piston compression to prevent pressure buildup. Keep an eye on the Brake Fluid level to ensure it does not overflow
  • After the job is complete, pump the brake pedal several times to push the caliper piston back up against the pads to ensure proper brake function

Attention California Customers - WARNING: Cancer and Reproductive Harm

Alternate/OEM Part Number(s): 125.62138

CENTRIC Warranty Information:
90 days/3,000 miles