SPECTRA PREMIUM
More Information for SPECTRA PREMIUM SP7050M
Continue Shopping
 
SPECTRA PREMIUM SP7050M  
$95.89
Price
 $0.00
Core
 + Sold in packs of 1x1
Pack
 $95.89
Total
Add to Cart
(Only 1 Remaining)
SPECTRA PREMIUM SP7050Mclose
<
>
Part image
The float arm (where pictured) may ship detached to prevent damage in transit. To connect, simply snap the wire end into the sender hole.
SPECTRA PREMIUM SP7050M Specifications
Fuel TypeGas
Gasket or Seal IncludedYes
In Tank or ExternalExternal
Inlet Quantity0
Lock Ring IncludedNo
Maximum Pressure65 PS
Minimum Pressure60 PS
Mounting Hardware IncludedYes
Negative GroundYes
Outlet Outside Diameter.375 IN
Outlet Quantity1
Outlet TypeQuick Connect
Resistance Ohms Empty995 Ohm
Resistance Ohms Full50 Ohm
Strainer IncludedNo
Voltage12 2H
Wire Harness IncludedNo
Spectra Premium fuel modules are constructed with innovative engineering, manufacturing technology and quality control to ensure it performs to the highest standards and expectations.
Benefits of Purchasing a Fuel Pump & Housing Assembly

Purchasing just the fuel pump is less expensive up-front, but a complete Fuel Pump & Housing Assembly provides added benefits:

  • Extend Service Life: New strainer(s), hoses, sensors and other components help resolve problems that could be caused by more than just the pump.
  • Reduce Install Time: Since you don't have to disassemble the housing, which could lead to damage, replacement becomes a simple swap, dramatically reducing installation time.
  • Save Money: The cost of the assembly is often cheaper than buying the components individually, and means you only have to do the job once.
Prevent Premature Fuel Pump Failure

Preventing premature fuel pump failure is far less expensive and time consuming than continuing to replace the pump. There are three common causes for premature fuel pump failure:

ELECTRICAL ISSUES
Poor electrical connections will mimic symptoms of a failed pump. Before replacing the pump:
  • Use a Fuel System Tester to test pump pressure is within expected range
  • Use an Electrical Tester to test for bad wiring, burnt or corroded connectors
  • Check / Replace faulty Fuse(s) and Relay

BEFORE REPLACEMENT
FUEL CONTAMINATION
Dirt, rust or debris in the fuel can clog strainers and stick to internal pump components. When replacing the pump:
  • Replace Fuel Filter or Fuel Strainer
  • Empty and clean the tank with Fuel Tank Cleaner
  • Fill tank with fresh, uncontaminated fuel of appropriate grade

DURING REPLACEMENT
PUMP DAMAGE / OVERHEATING
Running low on gas causes your fuel to heat up quicker, and your pump to work harder. After replacing the pump:
  • Maintain at least 1/4 tank of fuel and use a Fuel Additive / Conditioner to keep pump cool and lubricated
  • If vehicle is stored without use, drain tank to prevent pump corrosion from fuel oxidation

AFTER REPLACEMENT
Additional Resources

Warranty
Prop 65 Warning Symbol
WARNING:

Attention California Customers - Y. See www.p65warnings.ca.gov
OEM / Interchange Numbers: 04581410AE, 5136023AA, 5136023AB, 5136023AC, 5136023AD, 5136023AE, 5136023AF, 68053476AA, 68159764AA, 68159764AB, 68159764AC, 68159764AD, RL136023AC, RL136023AD

Warranty Information:
Lifetime