More Information for WVE 2M1345
Continue Shopping
WVE 2M1345  
WVE 2M1345close
Part image
WVE 2M1345 Specifications
Connector GenderFemale
Connector Quantity1
Connector ShapeOblong
Terminal GenderMale
Terminal Quantity2
Terminal TypeBlade
Vacuum Port Diameter (IN)0.300
Vacuum Port Quantity2
Also known as the Emission Control Canister Purge Solenoid, the Vapor Canister Purge Solenoid/Valve allows fuel vapor flow from the EVAP system. It transfers fuel vapors stored in the vapor canister into the engine's intake system by opening and closing as commanded by the engine's computer system. The solenoid is normally closed to prevent fuel vapors from entering the engine during a non-purge condition.

The vent solenoid, located near the EVAP canister inside a wheel well or under the vehicle near the fuel tank, usually fails before the purge solenoid. The purge solenoid will fail closed or will fail by sticking partially open illuminating a check engine light. When illuminated, common failure modes are:
  • Electrical failure of the purge valve control circuit
  • Electrical failure of the purge solenoid
  • Vacuum line leaks
  • Plugged vacuum line
WVE Vapor Canister Purge Solenoids/Valves are an exact match of OE specifications

Attention California Customers - WARNING: This product contains a chemical known to the State of California to cause Cancer and Reproductive Harm.

OEM / Interchange Numbers: 12632174

Warranty Information:
3 Years/36,000 Miles