|
DELPHI FG1230
|
|
$113.89
Price
|
$0.00
Core
|
+ Sold in packs of 1x1
Pack
|
$113.89
Total
|
|
|
|
|
|
| The float arm (where pictured) may ship detached to prevent damage in transit. To connect, simply snap the wire end into the sender hole. |
| DELPHI FG1230 Specifications |
|---|
| Average Current Draw | 8 Amp | | Average Flow Rating | 32 GP | | Connector Gender | Female | | Connector Quantity | 1 | | Connector Shape | Rectangle | | Fuel Filter Included | No | | Fuel Sending Unit Included | Yes | | Fuel Tank Pressure Sensor Included | No | | Fuel Type | Gas | | Gasket or Seal Included | Yes | | Gasket Or Seal Material | Nitrile Rubber | | Housing Material | Plastic | | In Tank or External | In Tank | | Inlet Type | Strainer | | Internal Or External Strainer | External | | Lock Ring Included | No | | Maximum Pressure | 94 PS | | Minimum Pressure | 51 PS | | Mounting Hardware Included | No | | Negative Ground | No | | Outlet Outside Diameter | 0.375 IN | | Outlet Quantity | 1 | | Outlet Type | Quick Connect | | Pump Design | Turbine | | Pump Type | Electric | | Regulator Included | No | | Resistance Ohms Empty | 20 Ohm | | Resistance Ohms Full | 500 ohm | | Strainer Included | Yes | | Terminal Gender | Male | | Terminal Quantity | 4 | | Terminal Type | Pin | | Voltage | 12 2H | | Wire Harness Included | No |
|
|
Delphi is a Tier 1 supplier to the majority of global vehicle manufacturers and has been a manufacturer of dependable fuel pumps and fuel delivery parts for over 80 years. With over 30 OE-proprietary innovations and 150 patents in fuel technologies, Delphi is regarded as a market leader in North American fuel management.
Features & Benefits:
- Delphi is a global OE manufacturer and all fuel pumps are built to Delphi's OE standards
- Empty float height and float retention matches OE specifications and guarantees correct gas gauge reading
- Lower amperage draws less load on vehicle's electrical system
- Lower failure rates due to its innovative design and durability
- Part is validated, tested and matched to the right vehicle application
 Benefits of Purchasing a Fuel Pump & Housing Assembly Purchasing just the fuel pump is less expensive up-front, but a complete Fuel Pump & Housing Assembly provides added benefits:
- Extend Service Life: New strainer(s), hoses, sensors and other components help resolve problems that could be caused by more than just the pump.
- Reduce Install Time: Since you don't have to disassemble the housing, which could lead to damage, replacement becomes a simple swap, dramatically reducing installation time.
- Save Money: The cost of the assembly is often cheaper than buying the components individually, and means you only have to do the job once.
 Prevent Premature Fuel Pump Failure Preventing premature fuel pump failure is far less expensive and time consuming than continuing to replace the pump. There are three common causes for premature fuel pump failure:
| ELECTRICAL ISSUES |
Poor electrical connections will mimic symptoms of a failed pump. Before replacing the pump:
- Use a Fuel System Tester to test pump pressure is within expected range
- Use an Electrical Tester to test for bad wiring, burnt or corroded connectors
- Check / Replace faulty Fuse(s) and Relay
BEFORE REPLACEMENT |
| FUEL CONTAMINATION |
Dirt, rust or debris in the fuel can clog strainers and stick to internal pump components. When replacing the pump:
- Replace Fuel Filter or Fuel Strainer
- Empty and clean the tank with Fuel Tank Cleaner
- Fill tank with fresh, uncontaminated fuel of appropriate grade
DURING REPLACEMENT |
| PUMP DAMAGE / OVERHEATING |
Running low on gas causes your fuel to heat up quicker, and your pump to work harder. After replacing the pump:
- Maintain at least 1/4 tank of fuel and use a Fuel Additive / Conditioner to keep pump cool and lubricated
- If vehicle is stored without use, drain tank to prevent pump corrosion from fuel oxidation
AFTER REPLACEMENT |
WARNING:
Attention California Customers - WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or reproductive harm. For more information go to www.P65Warnings.ca.gov.
|
| OEM / Interchange Numbers: 16116752626, 16116755043 |
Closeout Inventory Warranty Information:Wholesaler Closeout items have a 30 day warranty (but still are covered by our Return Policy).Regular Inventory Warranty Information:Lifetime |
|
