GM GENUINE
More Information for GM GENUINE 251500
{Alternate Inventory Numbers: 19168607}
Continue Shopping
 
GM GENUINE 251500close
Part image
GM GENUINE 251500 Specifications
Fan Clutch IncludedNo
Hub Flange Mount Hole Quantity4
Hub Height (MM)147.3
Impeller MaterialSteel
Impeller RotationStandard
Includes Back HousingYes
Includes Thermostat and HousingNo
Mounting Hardware IncludedNo
Outlet Port Quantity3
Pulley IncludedNo
Pump Mount Hole Quantity4
Related Cooling Fan ComponentsNone
Timing Belt IncludedNo
Water Pump Drive TypeV-Belt

Get the GM quality you know and trust with ACDelco's GM Original Equipment Water Pump line. Stay with the brand of parts your GM vehicle came with and get peace of mind that the fit, form, and function is up to the high standards and specifications of General Motors.

Features & Benefits

  • Manufactured to GM OE specification for fit, form, and function
  • Offering the quality, reliability, and durability of GM OE
  • GM-recommended replacement part for your GM vehicle's original factory component
  • Thoroughly tested for reliable, leak-free performance

Tips for Water Pump Servicing & Installation:
  1. Clean and reinstall the coolant recovery reservoir before flushing the cooling system.
  2. Flush the cooling system completely, using power flush equipment or thermal cycling the system with clean water three times. The most effective method of system flushing is to use a coolant exchanger, following the manufacturer's operating instructions.
  3. Do not use any non-approved flush agents, and replace the coolant according to manufacturer's specifications.
  4. Clean all sealing surfaces, and make sure all old gasket material is removed before installing your replacement component.
  5. Never strike the water pump shaft, since this will damage the new water pump.
  6. Torque all bolts according to the manufacturer's specifications, and adjust belts to proper tension (if applicable) to manufacturer's specifications.
  7. Use sealant tabs only if recommended. Some sealant tabs or similar compounds may restrict coolant flow through the passages of some cooling systems.
  8. With the new pump installed, turn the hub by hand and check for rotation.
  9. After installation, pressure-test the system for leaks and check for sufficient fan blade clearance between the blade and radiator shroud.
  10. Inspect related components in the cooling system, including your fan blades, fan clutch, engine mounts, radiator, belts and hoses, and reservoir.
Every belt driven water pump has a weep hole that might leak a little in the beginning. Some seepage from the weep hole is normal during the break-in period (about 10 minutes), and does not indicate a defect.
Cooling System Maintenance | Tips & Tools

Without regular maintenance, cooling system components will degrade and fail prematurely, which can lead to costly engine damage. Protect your engine with simple preventative maintenance:

  • Completely drain and flush the system using Cooling System Flush prior to installation. Flushing the system is critical to prevent system contamination and failure.
  • Consider replacing the Radiator Hoses (and Hose Clamps), Thermostat and Radiator Cap as part of routine preventative maintenance. System contamination can cause these parts to degrade and fail over time, which can lead to severe engine damage from overheating.
  • Refill radiator with fresh Coolant / Antifreeze according to the volume and formula specified in your Owner's Manual. Inspect levels and condition every year.
OEM / Interchange Numbers: 12522035

Warranty Information:
24 Month / Unlimited Mile Warranty