|
DORMAN 977025
|
|
$139.99
Price
|
$0.00
Core
|
+ Sold in packs of 1x1
Pack
|
$139.99
Total
|
|
|
|
|
|
| DORMAN 977025 Specifications |
|---|
| Adjustable | No | | Connector/Terminal Type | Pin | | Electrical Connection Type | Male | | Housing Color | Natural | | Housing Material | Aluminum/pbt | | Installation Hardware Included | No | | Package Contents | 1 Throttle Body Unit | | Terminal Count | M6 -1.0 | | Throttle Body Mounted | No | | Throttle Position Sensor Included | Yes |
|
|
This Dorman OE FIX 100% new electronic throttle body matches the original equipment part for fit and performance. With a corrosion-resistant aluminum body, it features a new sensor and circuit board for reliable performance. Features & Benefits:- Upgraded replacement - this electronic throttle body features enhanced internal components to prevent future failures
- New construction - 100% new case aluminum, not remanufactured, for reliability and convenience of no core charge
- Complete assembly - each unit includes new throttle position sensor for full repair
- Quality engineering - designed in the United States and backed by decades of automotive aftermarket experience
OE PROBLEM
Original equipment throttle bodies often fail from liquid intrusion and excessive wear on internal electronics |
This Dorman OE FIX features a non-moving Hall effect sensor and shaft seal to prevent future failures |
Experiencing Acceleration or Idling Issues? It Might Not be the Throttle Body!
Poor acceleration, hesitation and other idling issues can be caused by failure of a variety of parts. Use the chart below to help determine which part is causing the problem.
| Part | System | Other Symptoms |
|---|
| Throttle Body | Fuel & Air | |
| Mass Air Flow Sensor | Exhaust & Emission | - Difficulty Starting or Turning Engine
|
| Air Filter | Fuel & Air | - Dark Filter Media
- Debris in Filter or Filter Box (Change every year!)
|
| Fuel Injector | Fuel & Air | |
| Vacuum Hose / Connector | Hoses / Lines & Clamps | - Hissing, Squealing or Sucking Sound from Cracked Connector or Hose (Use a Vacuum Tester)
|
|
Spark Plug or Spark Plug Wire or Ignition Coil
| Ignition | - Increase in Exhaust Emissions
- Visible Wire Damage
- Oil Leak
|
| Accelerator Pedal Position Sensor | Interior | - Limp Mode
- No / Delayed Pedal Response
|
 Installation Tips - Perform OEM Recommended idle relearn procedure. Some applications may require the use of an OBD Scan Tool while others may refer to the Owners Manual.
- A relearn of idle values can be forced by disconnecting the negative battery cable for several minutes in order to clear the electronic control module's memory.
- Several minutes of idling and highway driving may be necessary to relearn idle values. Electrical loads such as headlights, AC, radio, etc. should be turned off while relearning.
- Erratic idle or engine surging after installation of replacement unit may be resolved by putting a load on the engine. If idle evens out after shifting into gear, shift back into park and check idle RPM - perform relearn again if a drivability condition is present.
- Clean intake manifold mounting surface and replace Intake Manifold Gasket, if necessary.
- Inspect Air Cleaner Intake Hose for cracks and proper sealing - replace or repair with Multi-Purpose Sealant, if necessary.
- Check harness for broken wires and wiggle connector to try and reproduce the problem. Replace or clean Connector, if necessary.
- Clear all diagnostic trouble codes from vehicle computer prior to idle relearn.
 Additional Resources
OE FIX
Attention California Customers - WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
|
| OEM / Interchange Numbers: 4891735AC, 4891735AD |
|
