|
BRUTE POWER 1010022
|
|
$54.79
Price
|
$0.00
Core
|
+ Sold in packs of 1x1
Pack
|
$54.79
Total
|
|
|
|
|
|
| The float arm (where pictured) may ship detached to prevent damage in transit. To connect, simply snap the wire end into the sender hole. |
| BRUTE POWER 1010022 Specifications |
|---|
| Contents | FUEL PUMP, SENDING UNIT, FLOAT, FUEL RESERVOIR, STRAINER, TANK SEAL | | Dual Filtration | No | | Fuel Sending Unit Included | Yes | | Gasket or Seal Included | Yes | | In Tank or External | In Tank | | Inlet Type | Strainer | | Maximum Flow Rating | 45 | | Maximum Pressure | 100 | | Outlet Quantity | 1 | | Outlet Thread Diameter | 0.375 | | Outlet Type | Quick Connect | | Strainer Included | Yes | | Terminal Quantity | 4 | | Terminal Shape | Rectangle | | Terminal Type | Blade | | Voltage | 12 |
|
|
| Improved Design with Internal Strainer |
Brute Power brings its automotive knowledge and high quality standards to Fuel Pumps!
Features:
- Re-engineered in the USA to provide OEM matching form and performance
- Innovative designs overcome common OE problems
- Stainless steel or appropriately plated metal components
- Ethanol compatible hoses and FKM rubber seals
- Motor armatures with carbon commutator and plastic over-molded sealed copper windings
- Endurance testing to ensure durability in low lubricity high ethanol fuels
- 20% and 85% Ethanol component soak testing
 Benefits of Purchasing a Fuel Pump & Housing Assembly Purchasing just the fuel pump is less expensive up-front, but a complete Fuel Pump & Housing Assembly provides added benefits:
- Extend Service Life: New strainer(s), hoses, sensors and other components help resolve problems that could be caused by more than just the pump.
- Reduce Install Time: Since you don't have to disassemble the housing, which could lead to damage, replacement becomes a simple swap, dramatically reducing installation time.
- Save Money: The cost of the assembly is often cheaper than buying the components individually, and means you only have to do the job once.
 Prevent Premature Fuel Pump Failure Preventing premature fuel pump failure is far less expensive and time consuming than continuing to replace the pump. There are three common causes for premature fuel pump failure:
| ELECTRICAL ISSUES |
Poor electrical connections will mimic symptoms of a failed pump, sometimes resulting in unnecessary replacement. Before replacing the pump:
- Use a Fuel System Tester to test pump pressure is within expected range
- Use an Electrical Tester to test for bad wiring, burnt or corroded connectors
- Check / Replace faulty Fuse(s) and Relay
BEFORE REPLACEMENT |
| FUEL CONTAMINATION |
Dirt, rust or debris in the fuel can clog strainers and stick to internal pump components. When replacing the pump:
- Replace Fuel Filter or Fuel Strainer
- Empty and clean the tank with Fuel Tank Cleaner
- Fill tank with fresh, uncontaminated fuel of appropriate grade
DURING REPLACEMENT |
| PUMP DAMAGE / OVERHEATING |
Running low on gas causes your fuel to heat up quicker, and your pump to work harder. After replacing the pump:
- Maintain at least 1/4 tank of fuel and use a Fuel Additive / Conditioner to keep pump cool and lubricated
- If vehicle is stored without use, drain tank to prevent pump corrosion from fuel oxidation
AFTER REPLACEMENT |
|
| OEM / Interchange Numbers: 5012380AD, 5018056AB |
BRUTE POWER Warranty Information:Limited Lifetime |
|
