• All base, body and air horns are stamped prior to disassembly to ensure units are reassembled with the proper “companion” parts. Internal parts such as jets and metering rods are identified, to ensure they remain with the original castings, where variations may have occurred at the manufacturing level. This process ensures that original flow characteristics are maintained.
• After disassembly all parts are inspected and cleaned in industrial equipment. Internal parts such as gaskets, needle and seats and plunger cups are discarded. All white metal castings are chemically processed to restore the factory finish. All aluminium castings are sandblasted or tumbler processed to restore the finish. Bases are surfaced to ensure proper mating with the body assembly and the manifold. Mounting holes are refaced to assure proper torque of mounting fasteners.
• During the sub-assembly process all threads, inlets and vacuum pipes are inspected and repaired or replaced if necessary. Throttle and choke plates are inspected and replaced if not serviceable. Throttle bushings are installed wherever throttle shaft play is not within tolerances. Completed base assemblies are checked for vacuum integrity. Any base that does not meet specifications must be repaired prior to use.
• Throughout the assembly process all body and calibration components are reassembled to the original unit to maintain product calibration. All assembly components are tested prior to product assembly.
• Completed product is flow tested throughout all ranges of operation to ensure proper calibration. Choke adjustment, idle speed and air-screw settings are made during product testing. This process allows the technician to start the vehicle upon product installation. Final adjustments may be necessary due to varied engine condition.
• All Autoline Carburetors are heat shrink packaged with installation instructions, mounting gaskets and specific technical bulletins.

Important Install Notices:

Choke Cover: Due to various manufacturer designs of choke covers, this part may not have the proper connectors for the vehicle application. If this occurs it is recommended that the choke cover from the old carburetor be used.

Warped EGR Plate: Before installing rebuilt carburetor the EGR plate or the spacer plate found between the carburetor and the manifold must be checked for warp age. Installing the carburetor on a warped plate can cause the mounting flange of the carburetor to break off. If this occurs warranty will be void.

Verhindern Sie Vergaserüberflutung / vorzeitiges Ausfallen!

• Vermeiden Sie Kraftstoffmischungen mit hohem Ethanolanteil. Informationen zu den Kraftstoffanforderungen finden Sie im Benutzerhandbuch.
• Ethanol kann Ablagerungen aus dem Kraftstofftank, den Kraftstoffleitungen und anderen Komponenten des Kraftstoffsystems, die ursprünglich nicht für Ethanolmischungen ausgelegt waren, lösen und entfernen.
• Ersetzen Sie immer den Kraftstofffilter und spülen Sie die Kraftstoffleitungen, wenn Sie den Vergaser ersetzen oder warten.
• Schmutz und Ablagerungen aus ungefiltertem Kraftstoff können sich zwischen Einlassventil und Sitz festsetzen und zu Überschwemmungen führen.
• Denken Sie daran, Kraftstoffstabilisator in den Kraftstofftank zu geben, wenn das Fahrzeug über einen längeren Zeitraum nicht gefahren wird.
• Kraftstoffstabilisator verhindert, dass Benzin verdampft und/oder klebrige Harze bildet, die den Vergaser verstopfen können.

Zusätzliche Hilfsquellen

Autoline Technischer Support

Wenn Sie Schwierigkeiten bei der Auswahl des richtigen Autoline-Teils haben oder Probleme während oder nach der Installation dieses Teils auftreten, stehen Ihnen die ASE-zertifizierten Techniker von Autoline zur Verfügung, um Ihre Fragen zu beantworten.

📧 E-Mail: tech@autoline.ca