ModuLite HD Protector Trailer Light Power Module & Installation Kit
Features & Benefits
The unit is rated for up to 4.2 amps for Turns/Stops circuits and 7.5 amps for the Taillight circuit
Draws power directly from the vehicle battery and uses less than 5mA of the vehicle circuit for sensing to turn the trailer functions on and off
Will work with either LED/Incandescent bulbs (vehicle & trailer)
Has integrated re-settable Short Circuit and Overload protection, to safeguard itself and the tow vehicle from shorts and installation wiring mishaps
Designed not to send feedback thru the vehicle circuits
The trailer brakes will override the hazard lamps when the brake is activated
The taillight circuit has been upgraded to work with vehicles that use a pulse width modulation (PWM), this will allow the converter to turn on fully and gives the trailer lights full brightness during activation
Will work with most vehicles that have a multiplex system for lighting
Will not work with vehicles with low-side switch
Can be used on a 2 wire or 3 wire system
All solid-state components in potted encapsulation
Includes integrated protective cover
You Need ModuLite If...
Trailer has more than one light assembly per side and is equipped with multiple clearance or running lights
If the tow vehicle may tow a variety of different trailers
Vehicle is equipped with lamp out sensors or other electronic devices that could be damaged by voltage fluctuations
Owners manuals caution against adding additional loads to electrical circuits
Additional Resources
Installation Instructions Attention California Customers - Warning: This product can expose you to chemicals such as DEHP, which is known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information go to: www.p65warnings.ca.gov